PDA

View Full Version : Ubiquiti SRC (300mW)


ioannou.alexandros
03-20-2009, 12:44 PM
Hi to all,

I bought a Ubiquiti SRC 300mW PCMCIA card since 2 weeks from an Ebay shop.However I was a little curious about what chipset this card I bought was using. Although everywhere I search on the net this card is shown that it uses an atheros AR5004 chipset the weird thing is that mines is based on the AR5001 model. I was wondering if actually Ubiquiti has ever released those particular cards with the AR5001 chipset built into them.

Thank you very much!

ioannou.alexandros
04-09-2009, 12:23 AM
Any Help ?

Nexus6
05-26-2009, 08:17 AM
Hi!

# lspci -vvnn
02:00.0 Ethernet controller [0200]: Atheros Communications Inc. Atheros AR5001X+ Wireless Network Adapter [168c:0013] (rev 01)
Subsystem: Atheros Communications Inc. Device [168c:1042]
Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B- DisINTx-
Status: Cap+ 66MHz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR- INTx-
Latency: 168 (2500ns min, 7000ns max), Cache Line Size: 128 bytes
Interrupt: pin A routed to IRQ 10
Region 0: Memory at 44000000 (32-bit, non-prefetchable) [size=64K]
Capabilities: [44] Power Management version 2
Flags: PMEClk- DSI- D1- D2- AuxCurrent=375mA PME(D0-,D1-,D2-,D3hot-,D3cold-)
Status: D0 PME-Enable- DSel=0 DScale=2 PME-
Kernel driver in use: ath5k_pci
Kernel modules: ath_pci, ath5k

AR5001X+ wrong value from EEPROM... should read AR5004X+

/Nexus6

CzechEnglishFrenchGermanItalianPolishPortugueseRussianSpanish
vBET 3.5.4 gives automatic translations