RB333 + SR9 + XR5

[tamahome]

Hi Im actually using the rb333 with sr9 and xr2, Im planning to set a new panel for 2.4 so I could remove the 2.4 omni from the rb333 and replace it with a XR5 with a 12db omni antenna.

Would it be any interference issue using this 2 cards in the same board? also the antennas would be next to each other, at 20cm

I want to try how 5.8 works and in the future if I needed replace the omni with 4 90º sector panels. So first I need to know about interference if they are in the same board and the antennas next to each other.

Thank you.

[WHT]

Router boards are designed to have multiple radios, therefore the interference between radios is negligible.

But the problems come with antenna spacing. I don't have tested results yet, but at least ten wavelengths. Of course there are some more variables.

[tamahome]

I thought the wont have many problems cause they were very different requencies, so..... this should be worst no that Im using a 2.4 omni next to the 900mhz omni =/