Bullet5 LAN errors

[zrob_12]

I am receiving lots of LAN errors on one of my clients radios. Speeds are very inconsistent and much slower then what they should be. What could be causing this?

70ft of cable from the Bullet5 to POE tested as good. Went ahead and replaced the cat5 connectors just in case and same result. POE plugs into a brand new router which I have tried replacing as well. Cat5 from POE to router is tested as good and has also been replaced. Any other ideas?

[UBNT-Mike.Ford]

Hello Zrob,

What voltage and amp power supply are you using for the 70ft run?

Thanks,

Mike

[zrob_12]

Standard power supply and POE that comes with NanoStation or PowerStation.

[Frotihngdog.ca]

Can you set the router to 10M-Auto?...If so, try that...could be a duplex issue.

What kind of a router are you using?

[zrob_12]

Using a Linksys standard wired router. I have also tried a Linksys WRT54G wireless router and witnessed the same result. I have used these routers in the past with Ubiquiti products and never had a problem.

[UBNT-Mike.Ford]

Hey Zrob,

Can you swat the BUllet 5 for a Nano5 just to test in this situation?

Thanks,

Mike

[zrob_12]

Mike,

I swapped the Bullet5 out with a Loco 5 and now see no errors on the LAN. Everything seems to be working fine now. Does this mean the Bullet5 is bad?

[WHT]

Swap the Loco with the Bullet and see if the Bullet is still dead.

[UBNT-Mike.Ford]

Any update?

Mike

[zrob_12]

I'm going to try the Bullet at another location this weekend. I will post results.

[UBNT-Mike.Ford]

Any new update?

Thanks,

[zrob_12]

Same results at another location, any other ideas?

[UBNT-Mike.Ford]

Hey Zrob,

Shoot me an email to mike@Ubnt.com. I want to get that unit back from you so I can test it.

Thanks,

Mike