1382
12-10-2008, 11:41 AM
How to disable CDP protocol on NS2.
View Full Version : CDP protocol
UBNT-Mike.Ford
12-10-2008, 12:46 PM
Hello 1382,
Asking my software team to jump in here.
Thanks,
Mike
Asking my software team to jump in here.
Thanks,
Mike
1382
12-11-2008, 12:12 PM
Give that to dial in to the console
rconaway
12-11-2008, 12:39 PM
Why would you want to turn that off?
Oliver
12-12-2008, 06:07 PM
Hm, I'm not sure these units actually support CDP. Maybe 1382 meant STP, or "Spanning Tree Protocol", which can be un-checked under the "Network"-tab.
Grtz,
Oliver
Grtz,
Oliver
1382
12-13-2008, 06:12 AM
http://www.protocols.ru/modules.php?name=Content&pa=showpage&pid=99
Destination: CDP/VTP/DTP/PAgP/UDLD (01:00:0c:cc:cc:cc)
Destination: CDP/VTP/DTP/PAgP/UDLD (01:00:0c:cc:cc:cc)
Oliver
12-13-2008, 10:46 AM
Hey 1382,
Ok, then are you sure the CDP-packets aren't being bridged from the switch at the other end of the link? On Cisco-gear, the interface-command "no cdp enable" usually shuts it off on the interface. If you don't have administrative rights on that switch, there might be a way to filter those packets, but I wouldn't bother. :-)
Grtz,
Oliver
Ok, then are you sure the CDP-packets aren't being bridged from the switch at the other end of the link? On Cisco-gear, the interface-command "no cdp enable" usually shuts it off on the interface. If you don't have administrative rights on that switch, there might be a way to filter those packets, but I wouldn't bother. :-)
Grtz,
Oliver
Translated to other languages thanks to vB Enterprise Translator 3.5.4