NS2 says cannot display webpage after UN & PW entered

[bajataz]

I have a new NS2 using firmware version 2.2.1 according to the locator,
this unit will ask for username and password which i figure is still ubnt and ubnt.
Once entered enternet exploerer says the webpage cannot be displayed HTTP error 500.

I have tried to use the reset button but no change.

[UBNT-Mike.Ford]

Hello Bajataz,

Please try and access the unit on the following url:

http://192.168.1.20/network.cgi

Then upgrade the firmware and the problem will not be there.


Thanks,

Mike

[guidonet]

I think it is not your first one, I suppose you got another one and you upgrade it first, because I found this problem with old firm Nanos.
Just clear your web browser cache... if it not work, try using this link
http://192.168.1.20/system.cgi

[bajataz]

It worked, i am in llike flynn lol Happy holidays to all !!!!

[kijoma]

hi,

also watch out, sometimes the browser defaults to the .cgi e.g. index.cgi instead of .html, you will get an annoying error then..

instead of bookmarking 192.168.1.20 , bookmark 192.168.1.20/index.html etc..

[UBNT-Mike.Ford]

Hey Guys,

This only happens if you have ran a V3.0 unit before through that browser. When you go to a unit after that with 2.2.1 you will get that error.

Upgrading fixes it :)

Mike

[kijoma]

hi,

as we had a load of units at 2.2.1 to upgrade on the bench we were constantly unplugging an upgraded to 3.x unit and plugging in a 2.2.1 etc..

took a while to work out what the hell was going on

changed the bookmark to explicitly go to the .html page and its fixed :)

[UBNT-Mike.Ford]

Great!

Mike