Please post your config files with every request!

[UBNT-Mike.Ford]

This will ensure faster responses on problems.. It can be downloaded from the system tab of your device.

Thanks,

Mike

[xpert976]

i got a PicoStation M2 HP with latest firmware v.5.2.1, but i cannot disable 802.11n type, i want to configure it in 802.11b/g but this option is not active. how can i change it? is there any way to change this from telnet?

http://img835.imageshack.us/img835/7517/captureax.jpg

aaa.1.status=disabled
wpasupplicant.status=disabled
wpasupplicant.device.1.status=disabled
wireless.status=enabled
wireless.1.wmmlevel=
wireless.1.wmm=enabled
wireless.1.wds=disabled
wireless.1.wds.6.peer=
wireless.1.wds.5.peer=
wireless.1.wds.4.peer=
wireless.1.wds.3.peer=
wireless.1.wds.2.peer=
wireless.1.wds.1.peer=
wireless.1.status=enabled
wireless.1.ssid=Net test
wireless.1.signal_led4=65
wireless.1.signal_led3=73
wireless.1.signal_led2=80
wireless.1.signal_led1=94
wireless.1.security=none
wireless.1.macclone=disabled
wireless.1.mac_acl.status=disabled
wireless.1.mac_acl.policy=allow
wireless.1.mac_acl.9.status=disabled
wireless.1.mac_acl.9.mac=
wireless.1.mac_acl.8.status=disabled
wireless.1.mac_acl.8.mac=
wireless.1.mac_acl.7.status=disabled
wireless.1.mac_acl.7.mac=
wireless.1.mac_acl.6.status=disabled
wireless.1.mac_acl.6.mac=
wireless.1.mac_acl.5.status=disabled
wireless.1.mac_acl.5.mac=
wireless.1.mac_acl.4.status=disabled
wireless.1.mac_acl.4.mac=
wireless.1.mac_acl.32.status=disabled
wireless.1.mac_acl.32.mac=
wireless.1.mac_acl.31.status=disabled
wireless.1.mac_acl.31.mac=
wireless.1.mac_acl.30.status=disabled
wireless.1.mac_acl.30.mac=
wireless.1.mac_acl.3.status=disabled
wireless.1.mac_acl.3.mac=
wireless.1.mac_acl.29.status=disabled
wireless.1.mac_acl.29.mac=
wireless.1.mac_acl.28.status=disabled
wireless.1.mac_acl.28.mac=
wireless.1.mac_acl.27.status=disabled
wireless.1.mac_acl.27.mac=
wireless.1.mac_acl.26.status=disabled
wireless.1.mac_acl.26.mac=
wireless.1.mac_acl.25.status=disabled
wireless.1.mac_acl.25.mac=
wireless.1.mac_acl.24.status=disabled
wireless.1.mac_acl.24.mac=
wireless.1.mac_acl.23.status=disabled
wireless.1.mac_acl.23.mac=
wireless.1.mac_acl.22.status=disabled
wireless.1.mac_acl.22.mac=
wireless.1.mac_acl.21.status=disabled
wireless.1.mac_acl.21.mac=
wireless.1.mac_acl.20.status=disabled
wireless.1.mac_acl.20.mac=
wireless.1.mac_acl.2.status=disabled
wireless.1.mac_acl.2.mac=
wireless.1.mac_acl.19.status=disabled
wireless.1.mac_acl.19.mac=
wireless.1.mac_acl.18.status=disabled
wireless.1.mac_acl.18.mac=
wireless.1.mac_acl.17.status=disabled
wireless.1.mac_acl.17.mac=
wireless.1.mac_acl.16.status=disabled
wireless.1.mac_acl.16.mac=
wireless.1.mac_acl.15.status=disabled
wireless.1.mac_acl.15.mac=
wireless.1.mac_acl.14.status=disabled
wireless.1.mac_acl.14.mac=
wireless.1.mac_acl.13.status=disabled
wireless.1.mac_acl.13.mac=
wireless.1.mac_acl.12.status=disabled
wireless.1.mac_acl.12.mac=
wireless.1.mac_acl.11.status=disabled
wireless.1.mac_acl.11.mac=
wireless.1.mac_acl.10.status=disabled
wireless.1.mac_acl.10.mac=
wireless.1.mac_acl.1.status=disabled
wireless.1.mac_acl.1.mac=
wireless.1.l2_isolation=disabled
wireless.1.hide_ssid=disabled
wireless.1.frameburst=0
wireless.1.fastframes=0
wireless.1.devname=ath0
wireless.1.compression=0
wireless.1.autowds=disabled
wireless.1.authmode=1
wireless.1.ap=
wireless.1.addmtikie=enabled
users.status=enabled
users.1.status=enabled
users.1.password=VvpvCwhccFv6Q
users.1.name=ubnt
tshaper.status=disabled
tshaper.out.1.devname=ath0
tshaper.in.1.devname=eth0
telnetd.status=enabled
telnetd.port=23
syslog.status=disabled
syslog.remote.status=
sshd.status=enabled
sshd.port=22
sshd.auth.passwd=enabled
snmp.status=disabled
route.status=enabled
route.1.status=enabled
route.1.netmask=0
route.1.ip=0.0.0.0
route.1.gateway=192.168.1.1
route.1.devname=br0
resolv.status=enabled
resolv.nameserver.2.status=disabled
resolv.nameserver.1.status=enabled
resolv.nameserver.1.ip=0.0.0.0
radio.status=enabled
radio.countrycode=840
radio.1.txpower=28
radio.1.tx_antenna_diversity=enabled
radio.1.tx_antenna=0
radio.1.thresh62g=
radio.1.thresh62b=
radio.1.thresh62a=
radio.1.subsystemid=0xe302
radio.1.status=enabled
radio.1.rx_antenna_diversity=enabled
radio.1.rx_antenna=0
radio.1.rts=off
radio.1.reg_obey=disabled
radio.1.rate.mcs=7
radio.1.rate.auto=enabled
radio.1.pollingpri=
radio.1.pollingnoack=0
radio.1.polling=disabled
radio.1.obey=disabled
radio.1.mode=master
radio.1.mcastrate=7
radio.1.ieee_mode=11nght40minus
radio.1.freq=2442
radio.1.frag=off
radio.1.forbiasauto=1
radio.1.ext_antenna=0
radio.1.dfs.status=enabled
radio.1.devname=ath0
radio.1.cwm.mode=2
radio.1.cwm.enable=0
radio.1.countrycode=840
radio.1.clksel=1
radio.1.chanshift=0
radio.1.cable.loss=0
radio.1.antenna.gain=0
radio.1.ampdu.status=enabled
radio.1.ampdu.frames=32
radio.1.ampdu.bytes=50000
radio.1.acktimeout=25
radio.1.ackdistance=600
radio.1.ack.auto=enabled
pwdog.status=disabled
ppp.status=disabled
ppp.1.status=disabled
ppp.1.password=
ntpclient.status=disabled
netmode=bridge
netconf.status=enabled
netconf.4.netmask=255.255.255.0
netconf.4.ip=0.0.0.0
netconf.4.hwaddr.status=disabled
netconf.4.devname=eth1
netconf.4.alias.8.status=disabled
netconf.4.alias.7.status=disabled
netconf.4.alias.6.status=disabled
netconf.4.alias.5.status=disabled
netconf.4.alias.4.status=disabled
netconf.4.alias.3.status=disabled
netconf.4.alias.2.status=disabled
netconf.4.alias.1.status=disabled
netconf.3.up=enabled
netconf.3.status=enabled
netconf.3.netmask=255.255.255.0
netconf.3.ip=192.168.1.20
netconf.3.hwaddr.status=disabled
netconf.3.devname=br0
netconf.3.autoip.status=enabled
netconf.2.up=enabled
netconf.2.status=enabled
netconf.2.promisc=enabled
netconf.2.netmask=255.255.255.0
netconf.2.ip=0.0.0.0
netconf.2.hwaddr.status=disabled
netconf.2.devname=ath0
netconf.2.allmulti=enabled
netconf.2.alias.8.status=disabled
netconf.2.alias.7.status=disabled
netconf.2.alias.6.status=disabled
netconf.2.alias.5.status=disabled
netconf.2.alias.4.status=disabled
netconf.2.alias.3.status=disabled
netconf.2.alias.2.status=disabled
netconf.2.alias.1.status=disabled
netconf.1.up=enabled
netconf.1.status=enabled
netconf.1.speed=100
netconf.1.promisc=enabled
netconf.1.netmask=255.255.255.0
netconf.1.ip=0.0.0.0
netconf.1.hwaddr.status=disabled
netconf.1.duplex=enabled
netconf.1.devname=eth0
netconf.1.autoneg=enabled
netconf.1.alias.8.status=disabled
netconf.1.alias.7.status=disabled
netconf.1.alias.6.status=disabled
netconf.1.alias.5.status=disabled
netconf.1.alias.4.status=disabled
netconf.1.alias.3.status=disabled
netconf.1.alias.2.status=disabled
netconf.1.alias.1.status=disabled
iptables.status=disabled
iptables.52.status=disabled
iptables.51.status=disabled
iptables.50.status=disabled
iptables.3.status=disabled
igmpproxy.status=disabled
httpd.status=enabled
httpd.session.timeout=900
httpd.port=80
httpd.https.status=disabled
ebtables.status=enabled
ebtables.52.status=disabled
ebtables.51.status=disabled
ebtables.50.status=disabled
ebtables.3.status=disabled
ebtables.3.cmd=-t broute -A BROUTING --protocol 0x888e --in-interface ath0 -j DROP
ebtables.2.status=disabled
ebtables.2.cmd=-t nat -A POSTROUTING --out-interface ath0 -j arpnat --arpnat-target ACCEPT
ebtables.1.status=disabled
ebtables.1.cmd=-t nat -A PREROUTING --in-interface ath0 -j arpnat --arpnat-target ACCEPT
dnsmasq.status=disabled
dnsmasq.1.status=enabled
dnsmasq.1.devname=eth0
dhcpd.status=disabled
dhcpd.1.status=disabled
dhcpc.status=disabled
dhcpc.1.status=disabled
dhcpc.1.devname=br0
bridge.status=enabled
bridge.1.stp.status=disabled
bridge.1.port.3.prio=20
bridge.1.port.3.devname=eth1
bridge.1.port.2.prio=30
bridge.1.port.2.devname=ath0
bridge.1.port.1.prio=10
bridge.1.port.1.devname=eth0
bridge.1.fd=1
bridge.1.devname=br0
aaa.status=disabled

[xpert976]

any answer for this?

[Bbobb]

Yes. First off this is the wrong place to post. The radios automatically select the appropriate connection type.

If you ever find the correct forum (It has "M" series in the group and 2.4 in the correct forum) and do a search there are a ton of messages to guide you in this matter.

Bob