Help with an WDS configuration

[bedward2]

I have just installed four NanoStation2's in a RV park to allow wireless internet connectivity to the residents. I am somewhat new to this type of wireless deployment and am struggling with getting everything working.

NanoStation #1 is connected to the internet and is configured as an Access Point WDS, the remaining three NanoStations are distributed throughout the park and are also configured as AP WDS. I can connect to the internet just fine while I'm within rage of unit #1 but cannot receive DHCP or ping unit #1 while connected to any other unit. I have tried various combinations of the "Wireless Mode" settings and have not stumbled upon one that works.

I'm fairly confident with all my settings except the "Wireless Mode". How should these units be configured? Station, Station WDS, Access Point or Access Point WDS?

It would be a real bonus if there were some basic configuration examples in the users guide to help those of us that are just starting out.

[robertoveras_Dominicano]

:?
I have same problem with my 2 NS2. I have one working as AP+WDS and the other one just can work as Station mode with a LAN cable connected. I had several days trying the second NS2 work as a repeater without success.

I you solved this issue ..please let me know how.

Thanks

[techbytes]

Maybe this is what you need.

http://forum.ubnt.com/forum/viewtopic.php?t=8067

[robertoveras_Dominicano]

Hummm.... Could be....could be. I will doble check my my 2 NS2 configuration and will let you know the results.

Regards.

[robertoveras_Dominicano]

:D Hey Brother ...
That was the issue. The "Enable Client Isolation: " was checked on the repeater. I unchecked the field and got wireless connections.

Thanks a lot for your help.

Regards.