boydsoftprez
02-06-2010, 03:06 PM
When I configure a UBNT device to use pppoe I click change then apply in AirOs v5. The remote station then proceeds to reboot but doesn't reappear until the unit has been power cycled. Most of the time after a power cycle the settings are as they were before the pppoe changes. Upon making the changes the second time on a fresh boot then click change, apply the units will then usually come back up with the proper settings... Sometimes they take a few times of changing the settings & pulling the power & putting it back again to get the stations to take the pppoe settings???? Any suggestions or ideas? Is this a bug in the firmware? I am running 5.1.1-wds. I have had this problem in in 5.1 & the new 5.1.1-wds. Not sure about earlier releases wasn't trying pppoe back then. As always thanks in advance.
