Invalid Firmware File

[mquinter]

hi,

I have a routerstation pro board and i want to use netshed for web interface.

The problem is that when i try to sent the firmware to the board (via tftp) i get the follow error: "Invalid Firmware File"

I try with NETSHe.bin getting from the web of the author and the same file that you recommend.

Please help me

[rct]

Where did you get the .bin file from? A few guesses:

Are you using binary mode to tftp it?

The RouterStation and RouterStation Pro use different firmware. Many of the .bin files from the routerstation firmware challenge are for the Routerstation only, not the pro. I believe Riskable posted an RSpro .bin with PyCI in the thread "Anyone try my firmware yet?". However that .bin had some issues. It's good enough to try PyCI though. I haven't seen if any of the other winners posted an RSpro .bin.

Also, there is a useful thread on flashing the RouterStation Pro on the OpenWRT wiki here: http://forum.openwrt.org/viewtopic.php?pid=98978#p98978

Help this helps.

[mquinter]

friend if I'm using binary mode.

Start with the transfer well and in the 12,898 block stops. The message is as follows::
DATA sent bytes> <block=12895, 512
ACK received <block=12895>
DATA sent bytes> <block=12896, 512
ACK received <block=12896>
DATA sent bytes> <block=12897, 512
ACK received <block=12897>
DATA sent bytes> <block=12898, 493
DATA sent bytes> <block=12898, 493
DATA sent bytes> <block=12898, 493
DATA sent bytes> <block=12898, 493
transfer timed out


I've tried several times

And also try the 0.09 version NETSH
Please help.

Thanks

[mquinter]

Fixed
I could put the fimware to RSPro, so make with the tftp tool under MS Windows.
Entire file was transferred.

Thanks for the information provided