Bridge Mode NanoLoco to Router Mode Bullet Ping Failure

[rbasil]

My simplified configuration is as follows

Notebook A <-> NanoLoco(AP-Bridge) <=> Bullet(Station-Router/NAT) <-> Notebook B

NotebookA -- 192.168.15.113
NanoLoco --- 192.168.15.1 AP, Bridge
Bullet WL ---- 192.168.15.2 Station, Router (running NAT)
Bullet Wired - 192.168.1.20 Wired LAN side
NotebookB -- 192.168.1.119

All IP's are static

My problem is NotebookB cannot ping NotebookA.

NotebookA can ping Nanoloco and both the LAN and WAN sides of the Bullet (which is surprising as NAT is enabled and I would think the LAN side would be firewalled).

NotebookB can ping both sides of the Bullet.

Obviously I have something wrong here but I just can't see it.

Any help is very welcome.

Thanks,
Rob

[rakpatel]

NotebookA -- 192.168.15.113
NanoLoco --- 192.168.15.1 AP, Bridge
Bullet WL ---- 192.168.15.2 Station, Router (NAT)

NotebookA can ping upto Bullet WL Becuase Same IP RAnge

Bullet Wired - 192.168.1.20 Wired LAN side
NotebookB -- 192.168.1.119

NotebookB can ping upto Bullet Wired Becuase Same IP Range

you required routing or add another Second IP address in either of notebook with same IP range of another Laptop

[rbasil]

Thanks for replying...

Notebook A <-> NanoLoco <=> Bullet <-> Notebook B


NotebookA -- 192.168.15.113
NanoLoco --- 192.168.15.1 AP, Bridge
Bullet WL ---- 192.168.15.2 Station, Router (NAT)

rakpatel> NotebookA can ping upto Bullet WL Becuase Same IP RAnge

I agree but, NotebookA can also ping 192.168.1.20 which is the wired side of the Bullet and should be isolated by NAT running on the Bullet.



Bullet Wired - 192.168.1.20 Wired LAN side
NotebookB -- 192.168.1.119

rakpatel>NotebookB can ping upto Bullet Wired Becuase Same IP Range

Again I agree but since the Bullet is running NAT, NotebookB should be able to ping NanoLoco and NotebookA.

The Bullet (running NAT) should handle the translation from LAN (wired) to WAN (wireless). The ping should go from NotebookB to Bullet (and NAT) to NanoLoco and to NotebookA.