Nano5M PtP link not working

[Jason O]

Got 2 Nano5M's for a short PtP link 800' or so. When I set up the link no matter what I did I could not get the CCQ above 60% Tried all channels different ACK timing. Went to 20Mhz and 100% I got these to replace the Nano5L's for better transfers. Got it on 170mbs wireless haven't done any large file transfers yet. Airmax off. not much 5ghz signals in area the ones that are in 5.8 range using 5.2 range.

[UBNT-Mike.Ford]

Got 2 Nano5M's for a short PtP link 800' or so. When I set up the link no matter what I did I could not get the CCQ above 60% Tried all channels different ACK timing. Went to 20Mhz and 100% I got these to replace the Nano5L's for better transfers. Got it on 170mbs wireless haven't done any large file transfers yet. Airmax off. not much 5ghz signals in area the ones that are in 5.8 range using 5.2 range.

Hello,

1. Please post the configuration files from using 40Mhz channel width.

2. What signal strenght do you have?

3. is it clear LOS?

4. Can you move to a higher frequency then 5.2Ghz?

Thanks,

[Jason O]

Don't have access to the 2 NanoM5 at the moment
42h/43v signal
Clear LOS
Tried almost all channels same thing

[cam]

how about turning the power down some, seems to be running a bit hot. Try getting your signal to around -60 and try some testing.