Best way to set bridge PtP with RM5?

[overburn]

I set up lately a PtP bridge with 2 rockets about 7,5 km link and got some problems. The bridge setup as Station wds and acces point wds, airmax disabled, ack auto, speed auto, got 2ms pings ofer the bridge but every few minutes got few times somwhere around 1000-3000ms and ccq floating between 100-80%. Then i started to change settings and finnaly got it working correctly. so my settings are now: Access Point, Station Airmax enabled, Speed 104m, ack 10,2km. now i got higher ping times after enablng airmax somwhere around 10-20 ms but got CCQ 100% and stable also the 1000-3000ms ping problem is gone.

My question is what are the best settings to set up a bridge with 2x rm5 in low noise enviroment?

[along5664]

Probably setting the ack from auto to manual is the change that made the difference.

[overburn]

acually the problem with the pings and ccq got solved after setting the sped to 104, I also noticed that when speed set to auto rocket often changed the speed between 162 and up and while chainging i got througput down for few seconds