Bullet M2 HP help

[petarda64]

Hello,
I bought 2 bullet m2 and i want to make one to work in Station mode
and the other one in AP mode. I understand that if i want to set this
devices is necessary to change the ip addres of the LAN in the MSDOS.
Can you exlain to me which are the steps i have to do.
-is like this how i enter in the MSDOS in windows xp :
Start -Run - and you type : cmd.exe ?
if not so can you explain me how should I do and What command should give that to send me to TCP\IP LAN!
Thank you very much and i wait your help.

[Griminal]

No. You need to specify an IP on the system you're going to use to configure the bullets. Set that machine to 192.168.1.100 or the like. Then you just use your browser to log into the bullets to change their settings. 192.168.1.20 is the default web interface address. The instructions are on the box the bullets came in.

[WHT]

You certainly could use the CLI (Command Line Interface or MSDOS window), but if you're not sure how to launch the cmd.exe command, I don't think you'll be comfortable downoading the cfg file and editing it with the MS-DOS Editor.

Just use the web GUI.

[petarda64]

Hello! Thank you very much it was a great help!
I ve made just like this : Local Area Connection - right click - properties-
Internet Protocol - OK- and i typed the IP address , etc.
And that is how i` ve connected myself in the main page of the Bullet.
Now, can you help me with the next steps to set up the Bullet?
Thank you very much and i wait for your answer!

[petarda64]

Now, can you help me with the next steps to set up the Bullet? :icon_sad:
Thank you very much and i wait for your answer!

[WHT]

http://www.ubnt.com/wiki
http://www.ubnt.com/kb