View Full Version : Clock
Shakespeare
09-30-2009, 11:04 AM
Has anyone figured out how to use the time clock feature on the M2HP? I have tried a variety of time servers: some update the clock to my (Eastern) time but do not update the date. I am running rc5.
It would be nice to have a way to set time zone and DST (on, off, auto) on the unit.
UBNT-Mike.Ford
10-02-2009, 05:40 PM
Has anyone figured out how to use the time clock feature on the M2HP? I have tried a variety of time servers: some update the clock to my (Eastern) time but do not update the date. I am running rc5.
It would be nice to have a way to set time zone and DST (on, off, auto) on the unit.
Hello,
For the timeservers, please make sure you have the DNS and gateway set properly on the devices.
Thanks,
Mike
Shakespeare
10-03-2009, 07:49 AM
Thanks, Mike.
As it turned out, I had swapped out my router above the M2HP at about the same time I installed it and had to adjust its settings to allow access to time servers. I didn't realize this fact until I noticed my computer's time was not updating either. The M2HP's clock works fine now.
UBNT-Mike.Ford
10-03-2009, 06:13 PM
Thanks, Mike.
As it turned out, I had swapped out my router above the M2HP at about the same time I installed it and had to adjust its settings to allow access to time servers. I didn't realize this fact until I noticed my computer's time was not updating either. The M2HP's clock works fine now.
Thanks for the update.
Mike
