2jarek
09-10-2009, 09:33 AM
In nosy environment UBNT CPE not working properly need change Hardware Retries to 4-7
In default UBNT no support Hardware Retries effect here
MIKROTIK CPE VS UBNT CPE :
http://img2.vpx.pl/up/20090910/mikrotik_cpe_vs_ubnt_cpe.jpg (http://www.vpx.pl/foto,mikrotik_cpe_vs_ubnt_cpe.html)
!!!!!!!!!!!Same place same signal strength connected on same sector antena who work in noisy environments!!!!!!!
UBNT-Mike.Ford
09-10-2009, 01:57 PM
Please post your configuration file.
Thanks,
2jarek
11-18-2009, 10:46 AM
Please post your configuration file.
Thanks,
wireless.1.addmtikie=enabled
wireless.1.ap=
wireless.1.authmode=1
wireless.1.compression=disabled
wireless.1.devname=ath0
wireless.1.fastframes=disabled
wireless.1.frameburst=disabled
wireless.1.hide_ssid=disabled
wireless.1.l2_isolation=enabled
wireless.1.macclone=disabled
wireless.1.rssi_led1=1
wireless.1.rssi_led2=15
wireless.1.rssi_led3=22
wireless.1.rssi_led4=30
wireless.1.scan_list.status=disabled
wireless.1.security=none
wireless.1.signal_led1=94
wireless.1.signal_led2=80
wireless.1.signal_led3=73
wireless.1.signal_led4=65
wireless.1.sper=disabled
wireless.1.ssid=www.jnet.republika.pl
wireless.1.status=enabled
wireless.1.wds=disabled
wireless.1.wmm=disabled
wireless.1.wmmlevel=-1
wireless.status=enabled
wpasupplicant.device.1.status=disabled
wpasupplicant.status=disabled
I paste wire config part.........i try optimistic, no auto EWMA & all possible combinations
&&&&&&
i told again only hardware retries in noisy environment guaranteed to work correctly link.
