rakpatel
09-05-2009, 07:03 AM
After Try in lot I found very simple and easy to make Interface for Router Station
1 Get Old PCs' MotherBoard connector for HDD LED or Reset Button etc. Get three of
them 1 for S_In, 2nd for S_Out, 3rd for GND
2 Make circuit on General Purpose board or Bread boaard
3. Connect DB9 FeMale connector to (Use only three wires as described in figure) circuit
and connect to PC
4. In hiperterminal slect COM1 Configuration 115200, 8, None, 1, None
and you will see perfect communication between RS and PC. This is some what call level shifter.
I had done this can anybody explain me how do step by step reflash entire RS and Reinstall again and than how to install Web Interface withh all latest firmware
Regards
1 Get Old PCs' MotherBoard connector for HDD LED or Reset Button etc. Get three of
them 1 for S_In, 2nd for S_Out, 3rd for GND
2 Make circuit on General Purpose board or Bread boaard
3. Connect DB9 FeMale connector to (Use only three wires as described in figure) circuit
and connect to PC
4. In hiperterminal slect COM1 Configuration 115200, 8, None, 1, None
and you will see perfect communication between RS and PC. This is some what call level shifter.
I had done this can anybody explain me how do step by step reflash entire RS and Reinstall again and than how to install Web Interface withh all latest firmware
Regards
