Nano5 External Status LED's

[Trizzly]

Hello I have a bridge between two Nano5's about 1.2 miles apart with LOS.

According to the antenna alignment tool my signal strength at the access point side is around -85 to -80 dbm. When I run the speed test I am getting about 30mbps.

I am happy with the speed, but I do think I should be able to be in the high 70's low 60's in terms of signal strength. I move the nano around but the external signal LED's dont change a bit. I only have red bar light up right now. Do the LED's not react in real time?

[Jason O]

They react in real time.

I would check the antenna Polarity on both units.

Jason

[Trizzly]

Then the first red one is always light up? I turned the nano 180 degrees and the red LED was still lite.

Right now I have the polarity set to adaptive on both units.

[UBNT-Mike.Ford]

Then the first red one is always light up? I turned the nano 180 degrees and the red LED was still lite.

Right now I have the polarity set to adaptive on both units.


Hello,

Please test with Adaptive off and let me know how the LED's look.

Thanks,