pkranger71
09-03-2009, 10:43 AM
I am still trying to get my bridge up and working. I followed the guide on the wiki to the letter. Is there anyway to access the AP via my connection here at home ( i am on the station side) as I said earlier the 2 nanostations see each other but I am not able to connect to the internet. Well I was for about 3 hours but no more. My eyes are bleeding from searching post. Could use some help.
Thanks again
Matt
pkranger71
09-03-2009, 11:38 AM
Just a update. When I use the discovery tool it shows 2 ubnt devices. They have the same ip (192.168.1.20) but different MAC address. When I double click on either one I am able to goto the GUI. Am I logging on to the same Nano despite the different MAC address??
Thanks again,
Matt
shapiros
09-03-2009, 02:46 PM
I am surprised that you had a connection for 3 hours. Basically, think of the two devices as being on the same network. If you have ANY two devices with the same IP, on the same subnet, you have a problem.
Have you tried leaving your IP on the AP Nano to 192.168.1.20 and the station to 192.168.1.21?
Also, since you are setting it up as a transparent bridge (I think), make sure both units have the same gateway, subnet and DNS's...
Sig
