NS M5 Second eth port

[HighlandsWireless]

Few questions about the second eth port

Is it bridged off the first port or is it routed through the on board system and if we chose to set the NS up in router mode the second port would get it's IP from the on board DHCP and would be able to communicate the the wireless users on the network?

VLAN questions;
Can the incoming side (WLAN) be set up as a VLAN under .1Q trunking?
Can the incoming side (WLAN) be set up as a trunked VLAN under .1Q trunking?
Can the second eth port (LAN) be set up as a VLAN under .1Q trunking?
Can the second eth port (LAN) be set up as a differant VLAN than the WLAN side under .1Q trunking?

John

[UBNT-Mike.Ford]

Few questions about the second eth port

Is it bridged off the first port or is it routed through the on board system and if we chose to set the NS up in router mode the second port would get it's IP from the on board DHCP and would be able to communicate the the wireless users on the network?

VLAN questions;
Can the incoming side (WLAN) be set up as a VLAN under .1Q trunking?
Can the incoming side (WLAN) be set up as a trunked VLAN under .1Q trunking?
Can the second eth port (LAN) be set up as a VLAN under .1Q trunking?
Can the second eth port (LAN) be set up as a differant VLAN than the WLAN side under .1Q trunking?

John


Hello,

It acts a simple switch and we do no support and form of VLAN tagging.

Thanks,

[HighlandsWireless]

Will you support this in the future as this would be VERY helpful?

[UBNT-Mike.Ford]

Will you support this in the future as this would be VERY helpful?

Hello,

We are wing towards something but do not have an estimated time frame on something like this.

Thanks,

Mike