"Real" information about

[AranBanjo]

Hi!

Some informations about M Series:
- Bullet M is MIMO??? And if so, how can It works with only ONE antenna connector?
- Which are the REALLY best performance you registered?

For Nanostation:
- Which are the REALLY best perfomance? (Someone has tested???)

Thanks and sorry for my really bad english :P

[UBNT-Mike.Ford]

Hi!

Some informations about M Series:
- Bullet M is MIMO??? And if so, how can It works with only ONE antenna connector?
- Which are the REALLY best performance you registered?

For Nanostation:
- Which are the REALLY best perfomance? (Someone has tested???)

Thanks and sorry for my really bad english :P

Hello,

1. Bullet M is not Mimo, that was a typo. It is single chain 11.n (1x1).

2. Maximup speeds I have seen were 103Mbps TCP/IP, but there is someone on the forum seeing ~120Mbps UDP traffic.


3. For NS5N, I have seen 147mbps TCP/IP traffic on a short link (less then 1mile)

Thanks,

Mike

[AranBanjo]

Thank You for quick reply.

Do You have information about products for link at 200 Mbps (full duplex 100mbps)? What can I use?

[WHT]

Some informations about M Series:
- Bullet M is MIMO??? And if so, how can It works with only ONE antenna connector?
http://forum.ubnt.com/forum/showthread.php?t=13157 Its an advertising oversight.

[UBNT-Mike.Ford]

Thank You for quick reply.

Do You have information about products for link at 200 Mbps (full duplex 100mbps)? What can I use?


Hello,

We only uses 802.11 hardware so we cannot provide a full duplex link. Also the use of 200Mbps full duplex would require full GigE support.

Thanks,

Mike

[george]

You can do full duplex 100Mbit using OSPF to channel up and down traffic over separate radio links.

http://blog.butchevans.com/2008/10/using-ospf-to-create-full-duplex-behaviour-for-wireless-links/

We are considering setting this up with two paired links of Bullets/Rockets.