SR71-E socket No 1 & No 0

[pkhetan]

Hello,

i want to install the SR71-E in a Clevo M860TU where i have 2 antenna cables, one with a WM2 label with a black end and the other is without any label and with a transparent end.
And in the mini-card itself i have 2 Sockets 0 & 1.
Which cable to connect with which socket ?

Thank you for your help

[UBNT-Mike.Ford]

Hello,

I would check with the manufacturer of the laptop to fine out witch is chain 1 and chain 0.

Thanks,

Mike

[hebeda]

usually it doest matter which antenna is connected to which antenna connector, because both antennas are the same. BUT you dont have an dualband antennas most likley inside your laptop, so dont run the card at 5ghz, you might destroy your card on the long term ( hint: standing wave)

[cgervasi]

BUT you dont have an dualband antennas most likley inside your laptop, so dont run the card at 5ghz, you might destroy your card on the long term ( hint: standing wave)
I haven't seen a high SWR damage a Ubiquiti card. I think at room temperature it's fine to run a card into a completely mismatched loan.

[Network_Pro]

I would not recoomend that with high power / long range equipment :) And I try not to do that with any card ;)