Bricked Pico2 - help needed

[DenaT]

Hello

I was building FW for Pico2 with SDK3.3.2. Suddenly firmware I've put into the device (through the UBNT gui) get the device bricked. Gui didn't say it was something wrong with it. When I plug the POE to it then only power led is on. Others are death. Recovery mode isn't working. Approach with serial port doesn't work either. Putty is not printing anything. I didn't found any information about Jtag in pico2. I think that probably something wrong had happen with redboot, because I've try to put one from original FW to my new build. Maybe someone can help me.

[MCunha]

This is a bug from Pico2: http://ubnt.com/forum/viewtopic.php?p=40470

Let it unplugged for a few minutes then plug it again. Should solve the problem...

If not, them run the umbrick procedure. Is quiet simple: http://www.ubnt.com/downloads/LS-Recovery.txt

Regards.

[DenaT]

Maybe I didn't write it clear enough. I try http://www.ubnt.com/downloads/LS-Recovery.txt and I try to unplug it for few minutes. I even open my pico and plug the serial cable in to it. But pico is still silent. I wrote about this in my previous post. But thanks anyway for replay.