Making firmware with SDK 3.3.2 for PicoStation

[DenaT]

Hi!!

I've got an Pico and I'm trying to make an FW for it. I've take SDK3.3.2 from UBNT page. I've change "flash selection" to "config_flash_8MB=y" and unset 4MB. But all I've got was an "bad firmware image". I also change fw-layout, but still no effect.

I've look for solution on UBNT pages and forum, but no luck. Can someone tells me what else I should do to get an valid fw?

[DenaT]

Hi!

After few research, I found out that when Pico is booting with firmware build by my self(i'm using SDK3.3.2), the boot progress is stopped on redboot with message " No image 'kernel' found". I've try to change fw-layout, but it fail.
This is the layout i'm using:
kernel 0x01 0xA8030000 0x000D0000 0x80041000 0x80041000 vmlinux.lzma
cramfs 0x02 0xA8100000 0x006C0000 0x00000000 0x00000000 squashfs.bin

Any suggestions?